GIS Data Catalog

Internal feature number.

Sequential unique whole numbers that are automatically generated.

Primary key for table lookup. Assigned by table creator.

Not Found

State FIPS. This is the two-digit code that corresponds to the State Federal Information Processing Standard (FIPS) code. This is a standard numbering system used by the Federal government, defined in FIPS Pub 6-4. These two numbers correspond to the first two digits of the panel number. Acceptable values for this field are listed in the D_State_FIPS table.

Not Found

Community or County Identification Number. This is the third through the sixth digits of the panel number. For community-based maps this corresponds to the FEMA Community Identification number. For countywide maps this is the county (or county equivalent) FIPS code with a “C.”

Not Found

Panel Number. This is seventh through the 10th digits in the complete panel number. This is assigned by the scale of the map and the position within the community or county. The panel number scheme is described in detail in the FIRM Panel Technical Reference.

Not Found

Map Suffix. This is the final digit in the complete panel number. This is a letter suffix at the end of the panel number. The map suffix is incremented one letter every time the panel gets republished.

Not Found

FIRM Panel Number. This is the complete 11-digit FIRM panel number, which is made up of ST_FIPS, PCOMM, PANEL and SUFFIX. This is the FIRM panel number that is shown in the title block of the map.

Not Found

Panel Type. The type of FIRM panel identifies whether the panel is printed or not and whether it is community based or countywide. Acceptable values for this field are listed in the D_Panel_Typ table.

Not Found

Effective Date. This is the effective date of the current map revision. This field is not populated until the FIRM effective date is established and the Final FIRM is ready for hardcopy production by FEMA. Then it is required.

Not Found

Map Scale. This is the denominator of the FIRM scale as a ratio. For example, 24000 is the denominator for a 1″ = 2000′ map. Acceptable values for this field are listed in the D_Scale table.

Not Found

Panel Not Printed Reason. This is the explanation for the FIRM panels that are not printed. Only completed if the hardcopy panel is not printed by FEMA. For example, “No Special Flood Hazard Areas.” See the FIS Report Technical Reference for commonly used values.

Not Found

NW_LAT

Not Found

NW_LONG

Not Found

SE_LAT

Not Found

SE_LONG

Not Found

Source Citation. Abbreviation used in the metadata file when describing the source information for the feature. The abbreviation must match a value in L_Source_Cit.

Not Found

Scale of map, in feet

Not Found

Feature geometry.

Coordinates defining the features.

Returns the area of a geometry instance in square units, based on the spatial reference identifier (SRID) of the geometry.

Double

Returns the total length of the elements in a geometry instance.

Double